题名 |
台灣水淬鋼筋在耐震結構之應用探討 |
并列篇名 |
Application of Controlled-Rolling Manufactured Defomed Steel Bars on Structural Seismic Design |
DOI |
10.6377/JA.200007.0119 |
作者 |
陳正誠(Cheng-Cheng Chen);黃世建(Shyh-Jiann Hwang);李宏仁(Hung-Jen Lee) |
关键词 |
水淬鋼筋 ; 鋼筋 ; 鋼筋混凝土 ; 耐震設計 ; heat-treated steel reinforcement ; steel reinforcement ; reinforced concrete ; earthquake-resistant design |
期刊名称 |
建築學報 |
卷期/出版年月 |
33期(2000 / 07 / 20) |
页次 |
119 - 131 |
内容语文 |
繁體中文 |
中文摘要 |
水淬鋼筋生產成本與售價皆比傳統高強度鋼筋低,台灣水淬鋼筋之市場占有率估計已超過50%,但其在耐震設計之適用性又多受到質疑。本文進行擬SD42水淬鋼筋之化學成份及應力-應變性質之試驗,並根據試驗數據求鋼筋挫屈應變,檢討水淬鋼筋在鋼筋混凝土構材韌性設計之應用。此外進行4之鋼筋混凝土懸臂梁之反復載重試驗,評估擬SD42水淬鋼筋對梁韌性之影響。研究結果發現:(1)水淬鋼筋偏高之實際降伏強度引致較高之梁彎矩與梁剪力,導致梁塑性變型以及消能機制之發展受到限制,其消耗總能量可下降達40%,延展性可下降達19%:(2)水淬鋼筋碳當量變異性大,顯示生產鋼筋之原料品質控制不佳:(3)水淬鋼筋與加釩鋼筋之挫屈應變互有高低,在規範之最低要求層次,擬SD42水淬鋼筋之挫屈潛能不比加釩鋼筋高。 |
英文摘要 |
In this research, controlled-rolling manufactured steel deformed bar specimens were tested to obtain stress-strain relationships and chemical compositions. In addition, four full-scale beam specimens were tested under cyclic loading to investigate the influence of controlled-rolling manufactured steel deformed bars on seismic behavior of beams. It is found that: (1) the beams using controlled-rolling manufactured steel deformed bars as reinforcement resulted in lower ductility and energy dissipation capacity; (2) the variation of carbon equivalent of controlled-rolling manufactured steel deformed bars were high, which indicates that the quality control of law material was poor; (3) the buckling strain of controlled-rolling manufactured steel deformed bars was higher than that of ordinary steel bars at the ratio of hoop spacing to the diameter of steel bar equals 8. |
主题分类 |
工程學 >
土木與建築工程 |
参考文献 |
|