Memory Effects of Polychlorinated Dibenzo-p-dioxin and Furan Emissions in a Laboratory Waste Incinerator

Jhong-Lin Wu；Ta-Chang Lin；Lin-Chi Wang；Guo-Ping Chang-Chien

PCDD/Fs ； Stack flue gas ； Laboratory waste ； Incineration ； Memory effect

Aerosol and Air Quality Research

14卷4期（2014 / 06 / 01）

1168 - 1178

英文

Laboratory wastes are discharged from experimental, testing, or analysis processes, and contain various toxic chemical compounds with a high heating-value and a high chlorine content (＞ 9%). Elevated PCDD/F (polychlorinated dibenzo-pdioxin and furan) emissions during start-up stages are caused by combustion of waste with high chlorine contents, incomplete combustion, and so called ”memory effects”. Even though the duration of cold start-up is short compared with the hours of continuous steady operation in a waste incinerator, its negative effects with regard to PCDD/F emissions on both human health and the environment cannot be neglected. A full-scale laboratory-waste incinerator which is operated for 10 days in each run and has 15 to 20 runs annually was investigated in this study. Eleven PCDD/F samples of stack flue gas were collected during the cold start-up periods (for 60.5 hrs). The gas temperature of the primary combustion chamber was above 850°C, and was maintained at between 850 and 900°C by injecting diesel fuel without waste feed. For first 1.5-7.5 hours, the PCDD/F concentration in the stack flue gas was as high as 0.656-1.15 ng I-TEQ/Nm^3. Afterward, during hours 10.5-35.5 and 54.5-60.5, this reduced to 0.159-0.459 and 0.218-0.254 ng I-TEQ/Nm^3, respectively. Based on principal component analysis (PCA) and the L/H ratio, the results revealed a higher L/H ratio (1.23) before hour 32, indicating that less chlorinated PCDD/F homologues (tetra and penta) dominated, while after hour 32 more chlorinated PCDD/F homologues (hexa, hepta and Octa) had a higher mass concentration and the L/H ratio fell to 0.42. These results indicate that the PCDD/F emissions during cold start-up were caused by memory effects and thermal desorption. Therefore, in order to reduce the PCDD/F emissions from the stack flue gas of waste incinerators, is highly recommended that a higher amount of activated carbon injection is used in front of the bag filters.